[Bucardo-general] Bucardo sync not running

[David Christensen]

Right; needs to be able to complete quickly, as VACUUM FULL will block writes, and hence transactions blocked by the trigger inserts.

> On Nov 3, 2018, at 7:01 PM, Michelle Sullivan <michelle at sorbs.net> wrote:
> 
> Check the delta table size... 
> 
> psql -U <a super user> <database>
> Db=# SET SCHEMA bucardo;
> Db=# SELECT COUNT(1) FROM bucardo.bucardo_<tablename>_delta;
> 
> ... repeat for all <tablenames> in the sync, see how many changes there are...
> 
> If a low number try VACUUM VERBOSE FULL ANALYZE bucardo.bucardo_<tablename>_delta; for each table.
> 
> Michelle Sullivan
> http://www.mhix.org/
> Sent from my iPad
> 
>> On 04 Nov 2018, at 05:27, Christophe Pettus <xof at thebuild.com> wrote:
>> 
>> 
>> 
>>> On Nov 1, 2018, at 09:35, David Christensen <david at endpoint.com> wrote:
>>> 
>>> So this is the same on source/target? Anything happening in the “bucardo” database?
>> 
>> On the source database, all the Bucardo connections are in place, but idle; same on the bucardo database.
>> 
>>> Is this multi-master or single master?
>> 
>> Single master.
>> 
>> Thanks!
>> --
>> -- Christophe Pettus
>>  xof at thebuild.com
>> 
>> _______________________________________________
>> Bucardo-general mailing list
>> Bucardo-general at bucardo.org
>> https://mail.endcrypt.com/mailman/listinfo/bucardo-general

--
David Christensen
End Point Corporation
david at endpoint.com
785-727-1171