[Bucardo-general] multi master

[Vitaly Burshteyn]

Going over your email, Bucardo_delta, the function that it is calling is now()

I am guessing that is not right.

Vitaly Burshteyn
Senior Network Engineer
Broadway.com, Theatre Direct International
729  7th Avenue
New York, New York 10019
Phone: 212.817.9117
Cell# 917-701-5732


-----Original Message-----
From: Greg Sabino Mullane [mailto:greg at endpoint.com] 
Sent: Monday, March 01, 2010 10:07 AM
To: Vitaly Burshteyn
Cc: bucardo-general at bucardo.org
Subject: Re: [Bucardo-general] multi master

On Sat, Feb 27, 2010 at 10:34:49AM -0500, Vitaly Burshteyn wrote:
> Doesn't look like it is.
> 
> Its interesting I have no problems with master - slave set up.  Yet 
> when I go to swap mode it goes bunkers.
> 
> Any tips on how to get bucardo_delta to be populate from the triggers?

Do the triggers exist on the table in question? If not, make sure you have done a 'bucardo_ctl validate all', which may add them [back] in.
If they are there, and bucardo_delta is not being populated, something is very wrong: make sure the function it is calling - most likely called bucardo_add_delta() - looks normal, and make sure that triggers are not disabled for the table in question.

-- 
Greg Sabino Mullane greg at endpoint.com
End Point Corporation
PGP Key: 0x14964AC8

____________________________________
The information contained in this transmission may contain privileged 
and confidential information.  It is intended only for the use of the 
person(s) named above. If you are not the intended recipient,  you are 
hereby notified that any review, dissemination, distribution or 
duplication of this communication is strictly prohibited. If you are 
not the intended recipient, please contact the sender by reply email 
and destroy all copies of the original message.